Eurovan V6-2792cc 2.8L (AES) (1998)
-
Connect VAG 1598118 Test Box to ECM wiring harness.
-
Switch multimeter to resistance range.
-
Check wiring for open circuit between central electric and Test Box socket 65 using wiring diagram:
-
wire resistance: 1.5 Ohms maximum
-
Connect multimeter between sockets 56 + 65 using jumper wires from VW 1594 adapter kit.
-
Switch ignition on.
-
Raise and rotate left front wheel or push vehicle to excite sensor.
-
Voltage must fluctuate between 0 and 4 Volts minimum
If wiring OK and voltage present between terminals 1 + 3:
-
Replace Speedometer Vehicle Speed sensor -G22-.
-
Read-out Readiness code. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Readiness Code Checking. See: Computers and Control
Systems/Testing and Inspection
If DTC memory has been erased:
-
Create Readiness code. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Readiness Code Generating See: Computers and Control
Systems/Testing and Inspection