Eurovan V6-2792cc 2.8L (AES) (1998)
/Page-895004.png)
1 - Hex-nut, tighten to 100 Nm
^
Always replace after disassembly
2 - Rear bearing for top control arm
^
Ejecting and pressing in Fig. 3
3 - Hex bolt
^
M 14 x 1.5 x 42
4 - Snap ring
^
Pry out using screwdriver
^
Always replace
5 - Upper ball joint
6 - Hex bolt, 60 Nm
^
M 1 2 x 1.5 x 22
7 - Eccentric bushing
^
Is marked with "R" at right of underside
^
Is marked with "L" at left of underside (arrow)
^
Mark installation position before removing
8 - Hexnut, tighten to 130 Nm
^
Only tighten when vehicle is standing on its wheels.
9 - Eccentric washer
10 - Rear bearing for bottom control arm
^
Pressing out go to Fig. 9
^
Installation position go to Fig. 10
^
Pretensioning go to Fig. 11
^
Pressing In go to Fig. 12
