Eurovan V6-2800cc 2.8L (AES) (2000)
Store modified value?
-
Press -Q- button to confirm input.
Indicated on display:
Channel 1 adaptation 3
->
Modified value has been stored
-
Press -> button.
-
Press buttons -0- and -6- to select "End Output" function 6.
NOTE: The "End Output" function only ends the storage procedure in the control module for anti-theft immobilizer -J362- but not the adaptation of
ignition keys.
-
Insert the next ignition key into ignition lock and switch on ignition for at least 1 second.
-
Repeat procedure until all keys have been adapted.
NOTE:
-
The adaptation of ignition keys is automatically terminated after 60 seconds. Time is not counted when ignition is switched off.
-
All ignition keys adapted before termination remain valid.
-
Following termination, it is not possible to re-adapt all ignition keys unless the "Login procedure" function is called up again.
-
All ignition keys, including keys that were adapted before termination, must be re-adapted.
-
Select "Check DTC memory", function 02.
-
Erase DTC entries "Key programming incorrect, adaptation limit exceeded" using function 05.
-
Check DTC memory again.
-
If there are no DTC's stored, then key adaptation was completed successfully.