Eurovan V6-2800cc 2.8L (AES) (2000)
Control Module: Service and Repair
NOTE: The basic setting should be initiated after performing the following repairs:
^
Exchanging engine
^
Replacing engine control module
^
Replacing/altering throttle valve
^
Adjusting throttle valve (setting idling speed).
^
Replacing Throttle Position (TP) Sensor -G69-
^
Altering TP Sensor -G69- setting, e.g. when adjusting closed throttle position switch (engine)
^
Replacing Diesel engine injection pump
^
Changes to control lever, altering setting of residual quantity or maximum speed adjustment screw on diesel engines
^
Replacing Transmission Control module -J217-
Procedure
-
Connect Scan Tool VAG 1551 and enter address word "02 Transmission electronics" and advance until "Select function XX" appears in the
display.
Rapid data transfer
HELP
Select function XX
-
Indicated on display:
-
Press keys 0 and 4. (The function "Initiating basic setting" is selected with 04).
NOTE: Accelerator Pedal must remain in closed throttle position.
Rapid data transfer
Q
04 Basic setting
-
Indicated on display:
-
Confirm entry with key 0.
Basic setting
HELP
Enter display group number XX
-
Indicated on display:
-
Press keys 0 and 0.
-
Confirm entry with key Q.
System in basic setting
0-->
-
Indicated on display:
The system is now in the basic setting.
-
Depress Accelerator Pedal as far as kick down and hold in this position for 3 seconds.
-
Press (arrow) key
Rapid data transfer
HELP
Select function XX
-
Indicated on display:
Select an additional function or function 06 to end output