Eurovan MV V6-2.8L (AXK) (2002)
Display shows all relevant diagnostic functions.
-
Select the desired function on display.
NOTE:
-
The display fields in functions 04 - basic setting and 08 - read measuring value block are listed from top to bottom.
-
The following test sequences are described for the VAG 1551 Scan Tool (ST).
VAG 1551, connecting
Test requirements:
-
All fuses OK according to wiring diagram.
-
Battery voltage must be at least 11.5 volts.
Procedure
-
Connect VAG 1551 Scan Tool (ST) using VAG 1551/3B cable.
NOTE:
-
If nothing is indicated on display, check voltage supply for VAG 1551 scan tool according to wiring diagram.
-
Depending on the program, additional operating information can be printed out by pressing the HELP button of the VAG 1551 scan tool.
-
The -> button is used for advancing through the program sequence.
-
The PRINT button is used for switching on the printer (lamp in button lights up).
Indicated on display:
VAG On Board Diagnostic (OBD)
HELP
1 - Rapid data transfer*
2 - Blink code output*
* Two operating modes are displayed alternately
-
Operate scan tool according to indications on display:
-
Press button 1 to select "Rapid data transfer" operating mode 1.
-
Continue On Board Diagnostic (OBD) of the vehicle system to be tested as described under "performing On Board Diagnostic (OBD)" See Table
of Contents
Initiating and Checking Control Module Versions
CAN-Bus On Board Diagnostic Interface, On Board Diagnostic (OBD), Initiating - Checking Control Module Versions
NOTE: The following description refers only to the VAG 1551 Scan Tool (ST).
Test requirements:
-
All fuses OK according to wiring diagram.
-
Supply voltage OK (at least 9.0 volts).
NOTE: Connect Scan Tool (ST). Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks" under "Accessories and Optional
Equipment/Antitheft and Alarm Systems/Alarm Module, (Vehicle Antitheft)".
-
Switch on ignition.
Indicated on display:
VAG - On Board Diagnostic (OBD)
HELP
1 - Rapid data transfer*
2 - Blink code output*
* Two operating modes are displayed alternately
NOTE:
-
If nothing is indicated on display, check voltage supply for VAG 1551 scan tool according to wiring diagram.
-
Additional instructions can be called up via the HELP button on the scan tool.
-
The -> button is used for advancing through the program sequence.
-
Function 00 "Automatic test sequence" can be performed in operating mode 1 "Rapid data transfer". This automatically checks all control modules
installed in the vehicle.