Eurovan MV V6-2.8L (AXK) (2002)
Alarm Module: Reading and Clearing Diagnostic Trouble Codes
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Checking (function 02)
NOTE: The displayed DTC in formation is updated only when initiating OBD or with "Erase DTC Memory" function 05.
-
Switch printer on via the PRINT button (indicator lamp in button lights up).
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -2- to select function 02," Check DTC Memory".
Indicated on display:
Rapid data Transfer
Q
02 - check DTC Memory
-
Press -Q- button to confirm input.
The number of stored malfunctions is indicated.
X malfunctions recognized!
DTCs are displayed and printed out in sequence.
-
Refer to DTC table and repair malfunctions as necessary. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/VAG Code Charts/Immobilizer System
If "No DTC recognized" is displayed, the program will return to the start position after the -> button is pressed.
No malfunction recognized!
->
Indicated on display:
Rapid data transfer
HELP
Select function XX
If something else is displayed:
-
End Output (function 06).
-
Switch off ignition and disconnect Data Link Connector (DLC).
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for reading diagnostic trouble codes without a scan tool.
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Erasing (function 05)
NOTE: If DTC memory cannot be erased, check DTC memory again and repair malfunction.
Requirements
-
DTC memory checked.
-
All malfunctions repaired.
After successful DTC memory check:
Indicated on display:
Rapid data transfer
HELP