GLI L4-2.0L Turbo (BPY) (2008)
/Page-370002.png)
Specified value: 5.0 to 8.0 ohms (at approx. 20° C)
If the specified value was not obtained:
-
Replace the Camshaft Adjustment Valve 1 (N205).
If the specified value was obtained:
Checking voltage
-
Switch the ignition on.
-
Using a Multimeter, check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 1 to Ground (GND) for voltage.
-
Switch the ignition off.
Specified value: battery voltage.
If the specified value was not obtained:
-
Check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 1 to the Motronic Engine Control Module (ECM) Power
Supply Relay (J271) socket 2/87 for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
