GLI L4-2.0L Turbo (BPY) (2008)
Checking Ground (GND)
-
Using a Multimeter, check the Selector Lever Sensor System Control Module J587 electrical harness connector terminal 1 to Ground (GND)
connection on right lower A pillar for resistance.
Specified value: 1.5 Ohms Max.
If the specified value was not obtained:
-
Check the Selector Lever Sensor System Control Module J587 electrical harness connector terminal 1 to Ground (GND) connection on right lower
A pillar for an open circuit or short to Battery (+).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
-
Erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Selector Lever Sensor System Control Module J587.
After the repair work, the following work steps must be performed in the following sequence:
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes