GLI L4-2.0L Turbo (CCTA) (2008)
Seals and Gaskets: Service and Repair
Left Flange Shaft Oil Seal, Replacing
Left Flange Shaft Oil Seal, Replacing
Special tools, testers and auxiliary items required
‹› Slide Hammer-Complete Set (VW 771)
‹› Pulling hook (VW 771/37)
‹› Thrust piece (3305)
‹› Torque wrench (V.A.G 1331)
‹› Torque wrench (V.A.G 1332)
‹› Sealing grease (G 052 128 A1)
Removing
-
Remove left wheel.
-
Remove noise insulation
-
Lower part of left front wheel housing liner, removing
-
Remove left drive axle.
-
Place appropriate receptacle underneath transmission.
-
Remove bolts for flange shaft, by installing two bolts into flange and counter-holding flange shaft using a pry bar.
-
Pull out flange shaft together with compression spring.
-
Pull out seal for flange shaft using a slide hammer (VW 771) and pulling hook (VW 771/37).
Installing
-
Lightly oil new sealing ring on outer circumference.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128).
-
Drive new seal to stop; be sure not to distort seal.