Golf Mk2
| Repairing rear axle |
Note| Welding and straightening on axle beam and stub axle is not permissible. |
| 1 - | Wheel bolt, 110 Nm |
| 2 - | Hexagon nut, 70 Nm |
| q | When nut is tightened, axle beam must be in the horizontal position (unladen vehicle state). |
| 3 - | Hexagon nut, 15 Nm |
| 4 - | Dished washer |
| 5 - | Hexagon nut, 25 Nm |
| 6 - | Cover (large) |
| 7 - | Upper bearing brush (rubber part) |
| 8 - | Cover (small) |
| 9 - | Coil spring strut |
| q | Removing and installing → Fig. |
| q | Dismantling and assembling → Chapter. |
| 10 - | Wheel bearing |
| q | Repairing vehicles with drum brakes → Chapter, vehicles with disc brakes → Chapter. |
| 11 - | Self-locking hexagon nut, 60 Nm |
| q | Use only self-locking nuts with captive washer. |
| q | When nut is tightened, axle beam must be in the horizontal position (unladen vehicle state). |
| 12 - | Hexagon bolt |
| q | Insert from centre of vehicle |
| 13 - | Flange bolt, 70 Nm |
| q | Reworking cap nut in longitudinal member when thread is damaged → Chapter. |
| 14 - | Bearing bracket with retainer for brake pressure regulator |
| q | Installation position → Fig.. |
| q | After installation, check overall toe of rear axle and adjust if necessary. |
| q | If possible do not loosen when removing rear axle |
| 15 - | Mounting bracket |
| 16 - | Hexagon nut, 35 Nm |
| 17 - | Bracket for regulating spring |
| 18 - | Bonded rubber bush |
| q | Note correct installation position → Anchor |
| q | Removing → Chapter |
| q | Installing → Chapter |
| 19 - | Axle housing with anti-roll bar |
| q | Stub axle contact surfaces and threaded holes are to be free of paint and dirt. |
| 20 - | Retainer for handbrake cable |
|
|
|
|