–
| Plug connector -1- onto wiring junction for terminal 15/TV 4 (above the relay plate with fuse holder) -2-. |
–
| Remove the push-in bridge from relay slot 11 and fit the horn relay in its place (if not already fitted). |
–
| Install relay plate with fuse holder and driver side trim. |
–
| Fit the airbag steering wheel with control unit and coil connector with slip ring onto the steering column (make sure steering is in centre position - wheels pointing straight ahead) and screw firmly in place. As a new part, the coil connector with slip ring is locked in centre position and is only unlocked when the steering wheel is screwed in place. |
Note Before installing the airbag steering wheel, sever the cable tie (zero position) on the coil connector with slip ring. |
|
|
|