Installation instructions |
The surfaces to be primed for the body kit parts should be completely clean. |
–
| Adhesive residue should be removed using adhesive remover -D 002 000 10-. |
–
| Soak cloth in silicon remover -LSE 020 100 A3-. |
–
| Clean area of application for adhesive bead twice thoroughly using cloth applied with solution and allow to dry. |
–
| Now apply primer using applicator -D 009 500 25- equally in one stroke. |
t
| Drying time approx. 10 minutes |
–
| Adhesive material should be applied to the primed areas of the body kit parts. |
WARNING Body kit parts should be installed within 10 minutes, or bonding properties of adhesive will be impaired. |
|
t
| Shutlines should be kept to an absolute minimum, up to approx. 1 mm. |
t
| Use adhesive tape to secure body kit part in position while curing. |
|
|
|