| –
| Swing door handle into door. |
| –
| Pull clip -1- into panel aperture and engage in door handle -2-. |
| –
| Fit lock cylinder housing in bearing plate of door handle at right angles. |
| –
| Now screw bolt in bearing plate using the socket driver. |
| The door handle engages back into the lock cylinder housing with an audible click. |
Note | Door handle -2- must be pressed against the door panel during assembly. |
| –
| Then perform remaining installation in reverse order of removal. |
| l
| It is essential that a functional check is then carried out as an incorrectly fitted and adjusted cable will mean the door cannot be opened. |
|
|
|
