Volkswagen Workshop Service and Repair Manuals > Golf Mk4 > Body | General body repairs, exterior | Rear door,sliding door,wing doors,central locking | Rear door | Removing and installing door lock

Installing

–	Pull operating lever -1- in direction of arrow.

–	Using a screwdriver, tension the spring -2- mounted on the door lock in the direction of the arrow and attach the lock lever to the spring.

Note

By hooking the operating lever in, the lock becomes locked. This prevents “incorrect” attachment of the Bowden cable at a later stage.

–	Guide wire through rubber boot in door and secure clips in door panel.

–	Insert assembly carrier in door.

–	Insert all bolts. Tighten bolts -1- and -2- in the sequence specified.

Torque setting: 8 Nm

–	The remaining bolts can be tightened in any sequence.

–	Install door window, see instructions on how to fit door window to window regulator → Chapter.

–	Continue installation in reverse order of removal.

l	Then perform functional check.

Volkswagen Workshop Service and Repair Manuals