Volkswagen Workshop Service and Repair Manuals > Golf Mk4 > Body | General body repairs, exterior | Sliding roof | Sliding/tilting sunroof with glass panel (Meritor) | Installing glass panel for sliding/tilting sunroof

Zero position:

The mark -arrow- on the rear of the guide upper section -1- must, on both sides, lie within the marks dimension -a- on the guide plate -2-.

The guide plate -2- must be located in the guide rails (cannot be moved by hand).

If this is not the case, adjust parallel running → Chapter.

–	Position sliding/tilting sunroof panel from above and screw in securing screws (coulisse guide rail/panel).

–	Lightly tighten securing screws (Torx T25).

–	Adjust sliding/tilting sunroof glass panel (height adjustment) → Chapter.

Note

t	After adjusting panel height, tighten securing screws (4.5 Nm).

t	On vehicles up to week 35/02, install upper and lower trim to match panel height adjustment.

Vehicles from week 36/02

On vehicles from week 36/02, a bellows is installed in place of the upper and lower trim.

Note

t	Bellows and trim should not be interchanged. Clearance between mechanical parts may otherwise be impaired.

t	Install bellows after panel height adjustment.

Volkswagen Workshop Service and Repair Manuals