Golf Mk4
| Assembly overview - sliding/tilting sunroof with glass panel |
| 1 - | Glass panel for sliding/tilting sunroof (single pane safety glass) |
| q | Removing sliding/tilting sunroof glass panel → Chapter. |
| q | Installing sliding/tilting sunroof glass panel → Chapter |
| q | Adjusting sliding/tilting sunroof glass panel → Chapter |
| 2 - | Panel seal |
| q | Renewing panel seal → Chapter |
| 3 - | Sliding headlining |
| q | Removing and installing sliding headlining → Chapter. |
| 4 - | Slide |
| 5 - | Lower trim |
| q | Up to week 35/02 |
| q | Removing → Chapter |
| 6 - | Upper trim |
| q | Up to week 35/02 |
| q | Removing → Chapter |
| 7 - | Water channel |
| q | Removed together with coulisse guide rail. |
| 8 - | End piece |
| q | To seal use butyl adhesive sealing cord -AKL 450 005 05-. |
| 9 - | Bolt |
| q | 3.5 Nm |
| 10 - | Carrier unit |
| q | Removing carrier unit → Chapter |
| q | U-frame (with guide channels): If necessary, grease guide channels using only special grease G 000 450 02. Otherwise correct operation may be impaired. |
| 11 - | Electric drive |
| q | Removing → Chapter |
| q | Adjusting drive mechanism (0 position) → Chapter |
| 12 - | Bolt |
| q | 3.5 Nm |
| 13 - | Crank for emergency operation |
| q | Clipped into cover of electric drive mechanism |
| 14 - | Cover |
| 15 - | Spring |
| 16 - | Wind deflector |
| q | Removing → Chapter |
| 17 - | Wind deflector mounting |
| 18 - | Torx screw |
| q | Torx T25 |
| q | 4.5 Nm |
| 19 - | Guide plate |
| q | Removing → Chapter |
| 20 - | Slide with cable |
| 21 - | Water channel slide |
| 22 - | Countersunk screws (microencapsulated) |
| q | Always use new countersunk screws |
| q | 3.5 Nm |
| 23 - | Bellows |
| q | From week 36/02 |
| q | Removing → Chapter |
| q | Installing → Chapter |
Note| Bellows and trim should not be interchanged. Clearance between mechanical parts may otherwise be impaired. |
