volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing parts of ESP system > < Checking or removing and installing rotor on rear axle (four-wheel drive)

Golf Mk4

Removing and installing rear speed sensor wiring (four-wheel drive)
Removing and installing rear speed sensor wiring (four-wheel drive)
Special tools and workshop equipment required
   
t  Wiring harness repair set -VAS 1978-
–  Obtain radio code on vehicles with coded radio.
–  Disconnect battery
–  Raise vehicle.
  W00-0447
–  Open cover -2- for connector -1-.
–  Disconnect speed sensor wiring connector -1- from speed sensor.
–  Remove rear side panel trim → General body repairs, Interior; Rep. Gr.70.
  N45-0147
–  Separate speed sensor wiring -arrow- from -VAS 1978- using wire strippers and remove defective wiring.
  N45-0173
–  Strip 15 mm of insulation from end of wire with wire strippers and bend half of stripped wire back.
–  Guide in new speed sensor wiring.
  N97-0016
–  Connect speed sensor to speed sensor wiring -1- and close connector cover -2-
–  Clip in speed sensor wiring -arrow-.
Ensure the wiring is not twisted when installing the speed sensor wiring in the wheel housing.
–  Cut 2-pin connector off new speed sensor wiring with wire stripper pliers.
–  Strip 15 mm of insulation from end of wire with wire strippers and bend back half.
–  Connect speed sensor wiring with aid of suitable crimp connector from wiring harness repair set -VAS 1978-.
  N45-0172

Removing and installing parts of ESP system > < Checking or removing and installing rotor on rear axle (four-wheel drive)