Golf Mk4
| Part lI (engine codes AEH, AKL) |
| 1 - | Knock sensor 1 -G61- |
| q | Checking: → Rep. Gr.01. |
| 2 - | 20 Nm |
| q | The torque setting influences the function of the knock sensor. |
| 3 - | Coolant pipe |
| 4 - | Oil dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings → Fig. |
| 5 - | Bracket |
| q | For ignition coil. |
| 6 - | 10 Nm |
| 7 - | 20 Nm |
| 8 - | Bracket |
| 9 - | 10 Nm |
| 10 - | Oil filter bracket with attachments |
| q | Dismantling and assembling → Chapter |
| 11 - | 15 Nm + 1/4 turn (90°) further |
| 12 - | Gasket |
| q | Renew |
| 13 - | 10 Nm |
| 14 - | Engine speed sender -G28- |
| q | Checking: → Rep. Gr.01. |
| 15 - | Connection |
| 16 - | 15 Nm |
| 17 - | Seal |
| q | Renew if damaged. |
| 18 - | Seal |
| q | Renew |
| 19 - | Thermostat |
| q | Checking: Heat thermostat in water. |
| q | Opening begins at approx. 86 °C. |
| q | Opening lift min. 7 mm |
| 20 - | 45 Nm |
| 21 - | Compact bracket |
| q | For poly-V-belt tensioner, alternator, power steering vane pump and air conditioner compressor. |
| 22 - | Cylinder block |
| q | Removing and installing sealing flange and pressure plate/drive plate → Chapter. |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter. |
| 23 - | Seal |
| q | Renew |
