volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Parts of cooling system body side > < Checking oil pressure and oil pressure switch

Golf Mk4

4cyl. Injection Engine, (2.0 ltr. Engine) (Mexico)
Removing and installing parts of cooling system
Removing and installing parts of cooling system
Warning:
When performing repair work, especially due to the confined conditions in the engine well, pay attention to the following:
  • ◆ Route all types of lines (e.g. for fuel, hydraulics, activated charcoal canister system, coolant, refrigerant, brake fluid and vacuum) as well as electrical wiring so that the original positions are restored.
  • ◆ Ensure sufficient clearance to all moving or hot components.
 
W00-0495

Notes:

  • ◆ When the engine is warm the cooling system is under pressure. If necessary release pressure before commencing repair work.
  • ◆ Hoses are secured with spring-type clips. In cases of repair only use spring-type clips.
  • ◆ → Assembly tool VAS 5024 or hose clip pliers V.A.G 1921 are recommended for fitting spring-type clips.
  • ◆ When installing coolant hoses route stress-free, so that they do not come into contact with other components (observe markings on coolant connection and hose).

Perform cooling system leakage test with cooling system tester V.A.G 1274 and adapters V.A.G 1274/8 and V.A.G 1274/9.

Parts of cooling system body side .

Parts of cooling system engine side => 19-7.

Coolant hose connection diagram => page 19-11

Draining and filling with coolant=> page 19-12.

Coolant mixing ratios => page 19-12, Draining and filling with coolant

Parts of cooling system body side > < Checking oil pressure and oil pressure switch