Volkswagen Workshop Service and Repair Manuals

Installing and adjusting multifunction switch -F125-

–  Place multifunction switch -F125- on selector shaft. Installation position:

Groove -1- in selector shaft must line up with mark -2- on multifunction switch -F125-.

–  Tighten securing bolts -arrows- for multifunction switch -F125- until finger-tight. –  Place setting gauge on selector shaft and secure it. –  Move selector shaft lever on gearbox to position “N”. –  Turn switch so that dowel hole in switch housing -1- lines up with hole in setting gauge.

–  Push in dowel pin -2- of setting gauge. –  Tighten securing bolts -arrows- for multifunction switch -F125- → Item.

–  Push on connector -2- of wire for multifunction switch. –  Push lever -1- onto selector shaft.

–  Tighten nut -arrow- → Item. –  Install selector lever cable → Chapter. –  Install battery and battery holder → Electrical system; Rep. Gr.27. –  Connect earth strap to battery. –  Code radio → Radio, telephone, navigation; Rep. Gr.91.