Golf Mk4
|
1 - | Plug, 15 Nm |
q | Always renew oil seal |
2 - | Overflow pipe |
3 - | Drain plug, 45 Nm |
q | Only renewing if oil is to be drained. |
4 - | Seal |
q | Always renew |
5 - | Gearbox housing |
6 - | Hexagon nut, 20 Nm |
7 - | Lock washer |
8 - | Lever |
q | For selector shaft |
9 - | Bolt, 6 Nm |
10 - | Multifunction switch -F125- |
q | Removing, installing and adjusting → Chapter. |
q | Can be checked using “guided fault finding” of -VAS 5051-. |
11 - | Retaining clip |
q | For wiring harness on gearbox housing. |
12 - | Wiring harness |
q | For solenoid valves, engine speed sender and ATF temperature sender. |
13 - | O-ring |
q | Always renew |
q | For connector/wiring harness. |
14 - | Seal |
q | Always renew |
q | Removing and installing → Chapter |
15 - | Seal |
q | Always renew |
q | Removing and installing → Chapter |
16 - | Valve body |
q | Removing and installing → Chapter |
17 - | Cap |
q | To secure plug |
q | Always renew |
18 - | Plug |
19 - | O-ring |
q | Always renew |
20 - | Breather cap |
21 - | Bolt, 8 Nm |
22 - | Valve body cover |
q | Removing and installing → Chapter |
23 - | Bolt |
q | Torque setting → Chapter |
q | Complying with the dismantling and assembling procedure → Chapter. |
24 - | Wiring harness |
q | For engine speed sender and ATF temperature sender. |
25 - | Spool valve |
q | Secure against falling out before removing the valve body. |