| –
| Tighten 12-point nut to 120 Nm, measure friction torque → Chapter and if necessary increase tightening torque until specified friction torque is attained. |
| –
| Turn torque wrench -V.A.G 1332- to right to tighten. |
| –
| Use 1/2” to 3/4” adapter. |
Note | Increase torque setting slowly and check friction torque at regular intervals. If the prescribed friction torque is exceeded, the spacer sleeve must be renewed and the adjustment repeated. A spacer sleeve which has been compressed too much cannot be reused. |
|
|
|
