Golf Mk4
| Adjustment and marking of final drive gear sets |
| A - | Bevel gear with stub shaft |
| A - | Shaft bevel gear |
| 1 - | Pair number of final drive gear set |
| q | In example: 5050 |
| 2 - | Shaft bevel gear allowance (D = +2) |
| q | Adjustment dimension for production |
| 3 - | Backlash (Sd = 0.12) |
| q | Check dimension |
| 4 - | Dimension „R“: actual dimension between bevel gear with stub shaft and face of shaft bevel gear at point with quietest running for this gear set. |
| q | In example: R = 34.14 means R = 43.14 mm |
| C - | Actual dimension between axis of bevel gear with stub shaft and back of shaft bevel gear at point of quietest running for this gear set. It is 70.00 mm |
| Ro - | Length of test machine master gauge used. „Ro“ = 42.70 mm |
| r - | This allowance „r“ must first be determined → Chapter. |
