Golf Mk4
| III - Removing and installing freewheel and reverse gear brake -B1- |
| Overview - all parts → Chapter |
| Dismantling → planetary gearbox → Chapter, |
| Assembling → Chapter. |
| Installing exchange component → Chapter. |
| 1 - | Retaining ring |
| q | For support tube -B2-. |
| q | Installation position: open ends of retaining ring face freewheel retaining wedge. |
| 2 - | Retaining ring |
| q | For freewheel. |
| q | Installation position: open ends of retaining ring face freewheel retaining wedge. |
| 3 - | Freewheel with -B1- piston |
| q | Before removing freewheel, remove → valve body and plug → Chapter. |
| q | Dismantling and assembling → Chapter |
| 4 - | Dished spring |
| q | Smaller diameter faces freewheel. |
| 5 - | Pressure plate -B1- |
| q | Install with flat side facing plates. |
| q | Parts are allocated according to gearbox code letters. |
| 6 - | Inner plate -B1- |
| q | Quantity of inner plates -B1- → Chapter. |
| q | Lay in → ATF for 15 minutes before installing |
| 7 - | Outer plate -B1- |
| q | Quantity of outer plates -B1- → Chapter. |
| 8 - | Shim |
| q | Determining thickness ⇒ Adjusting reverse gear brake -B1- → Chapter |
| q | 1 or 2 shims may be installed. |
| 9 - | Gearbox housing with planet carrier installed |
