volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Notes on installing > < Notes on removing

Golf Mk4

Securing engine to assembly stand
Securing engine to assembly stand
When working on engine, secure it with engine and gearbox support -VW 540- and engine and gearbox support supplement -VW 540/1 B- to support clamp -VW 313- of the assembly stand.
Procedure
–  Remove gearbox.
Vehicles with automatic gearbox:
–  Secure torque converter against “falling out” after separating engine from gearbox.
Continuation for all vehicles:
   
–  Attach lifting tackle -2024 A- as follows and lift off engine and gearbox jack -V.A.G 1383 A- using workshop crane.
Belt pulley end: 3rd hole in hook at position 2.
Flywheel end: 3rd hole in hook at position 8.
  WARNING
The hooks and locating pins must be secured with locking pins.
  Note
t  The positions marked 1...4 on the bar must be towards the pulley end.
t  The holes in the hooks are counted up from the hook.
–  Secure engine to support clamp -VW 313- using engine and gearbox bracket -VW 540- and supplementary set for engine and gearbox support -VW 540/1 B-. Dowel sleeves must be removed.
  N10-0149

Notes on installing > < Notes on removing