volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Renewing valve stem seals

Golf Mk4

Removing
Removing
–  Remove camshaft → Chapter.
–  Remove rocker roller fingers. Lay them aside on a clean surface.
–  Ensure that roller rocker fingers are not interchanged.
–  Pull off spark plug connectors using assembly tool -T10029-.
–  Remove spark plugs using spark plug spanner -3122 B-.
–  Set piston of respective cylinder to “bottom dead centre”.
   
–  Fit valve assembly tool -2036- and adjust mountings to height of studs.
–  Screw pressure hose -VW 653/3- into spark plug thread.
–  Connect pressure hose to compressed air source of at least 6 bar.
–  Remove valve springs using valve lever -VW 541/1 A- and thrust piece for VW 541 / 1 A and 2037 -VW 541/6-.
  Note
Tight cotters can be loosened by tapping lightly on lever.
–  Pull out valve stem seals using valve stem seal puller -3364-.
  N15-0399

Installing > < Renewing valve stem seals