Volkswagen Workshop Service and Repair Manuals > Golf Mk4 > Power unit | 4-cylinder injection engine (1.6 l engine, roller rocker fingers), Mechanics | Engine lubrication | Removing and installing parts of lubrication system | Removing and installing sump

Removing

–	Install middle, left and right noise insulation trays: → Rep. Gr.50.

–	Drain engine oil.

Note

Observe environmental regulations for disposal.

–	Pull 3-pin connector off oil level and oil temperature sender -G266-.

–	Remove sump. If necessary, loosen sump using light blows with rubber-headed hammer.

–	Remove sealant residue on cylinder block with a flat scraper.

–	Remove sealant residue on sump using a rotating brush, e.g. a hand drill with a plastic brush attachment (wear protective glasses).

–	Clean sealing surfaces. They must be free of oil and grease.

Volkswagen Workshop Service and Repair Manuals