Golf Mk4
Note
|
| 1 - | Thermostat housing |
| 2 - | 10 Nm |
| 3 - | Thermostat |
| q | Installation position: breather slot/valve points upwards |
| q | Checking: Heat thermostat in water. |
| q | Opening begins at approx. 80 °C. |
| q | Ends at approx. 105 °C. |
| q | Opening lift min. 7 mm. |
| 4 - | Seal |
| q | Renew |
| 5 - | Connection |
| 6 - | Sleeve |
| 7 - | 10 Nm |
| 8 - | O-ring |
| q | Renew |
| 9 - | Connection |
| 10 - | Coolant temperature sender -G62- |
| q | With coolant temperature gauge sender -G2-. |
| q | For engine control unit. |
| q | If necessary, release pressure in cooling system before removing. |
| q | Checking: → Motronic injection and ignition system (5-cyl. engine); Rep. Gr.01 |
| 11 - | Air conditioner shut-off thermal switch -F163- |
| q | For air conditioner |
| q | If necessary, release pressure in cooling system before removing. |
| 12 - | Securing clip |
| q | Check for secure seating. |
