Golf Mk4
Assembly overview - parts of ignition system for engine codes BDE, BFH, BJS and BML |
1 - | Ignition coil 1 with output stage -N70- |
q | Ignition coil 2 with output stage -N127- |
q | Ignition coil 3 with output stage -N291- |
q | Ignition coil 4 with output stage -N292- |
q | Ignition coil 5 with output stage -N323- |
q | Ignition coil 6 with output stage -N324- |
q | Remove using puller -T10095 A- → Chapter. |
2 - | Connector |
q | 4-pin. |
3 - | Bracket |
q | For connector for knock sensor 1 -G61-. |
4 - | 10 Nm |
5 - | Connector |
q | Black, 3-pin. |
q | Gold-plated contacts on sensor and connector. |
6 - | Knock sensor 1 -G61- |
q | Gold-plated contacts on sensor and connector. |
q | Location: cylinder block exhaust side |
7 - | 20 Nm |
q | The torque setting influences the function of the knock sensor. |
8 - | Exhaust camshaft adjuster |
q | With sender wheel for Hall sender 2 -G163- |
q | Removing and installing → Chapter |
9 - | Cover |
q | Removing and installing → Chapter. |
10 - | Seal |
q | Renew. |
11 - | Hall sender 2 -G163- |
q | For exhaust camshaft. |
q | Gold-plated contacts on sensor and connector. |
12 - | 10 Nm |
13 - | Connector |
q | Black, 3-pin. |
q | Gold-plated contacts on sensor and connector. |
q | Mark connector before removing. |
14 - | Hall sender -G40- |
q | For inlet camshaft. |
q | Gold-plated contacts on sensor and connector. |
15 - | Knock sensor 2 -G66- |
q | Gold-plated contacts on sensor and connector. |
q | Fitting location: cylinder block intake side. |
16 - | Connector |
q | Black, 2-pin |
q | Gold-plated contacts on sensor and connector. |
17 - | Inlet camshaft adjuster |
q | With sender wheel for Hall sender -G40- |
q | Removing and installing → Chapter |
18 - | Spark plug |
q | Remove and install with spark plug socket and extension -3122 B-. |
q | Type, specified torque and electrode gap → Chapter |
19 - | Valve timing housing |
q | For camshaft adjustment. |
q | Removing and installing → Chapter |