Volkswagen Workshop Service and Repair Manuals > Golf Mk4 > Power unit | Direct injection and glow plug system with distributor pump as of 05.99 | Self diagnosis, V.A.G Inspection Service | Self-diagnosis | Connecting fault reader V.A.G 1551 and selecting engine electronics control unit

Connecting fault readerV.A.G 1551 and selecting engine electronics control unit

Connecting fault reader -V.A.G 1551- and selecting engine electronics control unit

Special tools and workshop equipment required

t	Fault reader -V.A.G 1551-

t	Diagnosis cable -V.A.G 1551/3-

Note

t	The vehicle system tester -V.A.G 1552- can be used instead of the fault reader -V.A.G 1551-, however a print-out is not possible.

t	All fault reader -V.A.G 1551- and vehicle system tester -V.A.G 1552- functions can also be carried out with the new vehicle diagnosis, testing and information system -VAS 5051-. Connect vehicle diagnosis, testing and information system -VAS 5051- → Chapter.

Test prerequisite

l	Fuse 12 OK.

l	The battery voltage must be at least 11.5 V.

l	Earth connections between engine (on gearbox bell housing) and body (below battery) OK.

Procedure

–	Pull cover -1- off in -direction of arrow-.

–	Connect fault reader -V.A.G 1551- with diagnosis cable -V.A.G 1551/3-.

When the fault reader has been connected:

–	Depending upon desired function: Switch ignition on or start engine, table “Selectable functions” → Chapter.

Note

t	If the display remains blank, check voltage supply for diagnostic connector: → Current flow diagrams, Electrical fault finding and Fitting locations

t	If the display does not indicate as described in the work sequence: → Fault reader operating instructions

t	If due to an input fault “fault in the data transfer!”is displayed, pull wire off fault reader, reconnect and repeat work step.

Indicated on display:

V.A.G SELF-DIAGNOSIS                HELP

 1 - Rapid data transfer*

¹⁾	Appears alternately

–	Operate fault reader taking into account the information on the display:

–	Press button 1 for “rapid data transfer”.

–	Press buttons 0 and 1 for address word “Engine electronics” and confirm the input with Q button.

V.A.G SELF-DIAGNOSIS                HELP

 2 - Flash code output*

The fault reader -V.A.G 1551- display will show the control unit identification, e.g.:

t	038906018D = Part No. of the control unit (for up-to-date control unit version see parts catalogue)

t	1.9 l = engine displacement

t	R4 = type of engine (4-cyl. in-line engine)

t	EDC = Injection system (Electronic Diesel Control)

t	G = Vehicles with cruise control system (no display = no cruise control system)

t	SG = Gearbox type: manual gearbox (AG = automatic gearbox)

t	1817 = Control unit software version

t	Coding 00000 = coding variant

t	WSC xxxxx = Workshop code from fault reader -V.A.G 1551- with which coding was last carried out. (If the factory coding has not been changed, WSC 00000 appears)

–	Press → button.

038906018D  1.9l  R4  EDC  GSG    1817->

Coding 0000                     WSC00000

Indicated on display:

–	Further measures see repair procedures.

Rapid data transfer                 HELP

Select function XX

Volkswagen Workshop Service and Repair Manuals