volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Final control diagnosis > < Fault code 16485 … 65535

Golf Mk4

Clear fault memory
Clear fault memory
Special tools and workshop equipment required
t  Fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- with diagnosis cable -V.A.G 1551/3-
Test prerequisite
l  Fault eliminated
  Note
After eliminating faults the fault memory must be interrogated again as follows and then erased.
Procedure
–  Connect fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- and select control unit for engine electronics with “address word 01”. Engine must be idling. (Connecting fault reader and selecting engine electronics control unit → Chapter.)
   
Indicated on display:
–  Press keys 0 and 2 for function “Interrogate fault memory” and confirm entry with Q key.
  
Rapid data transfer                 HELP
Select function XX
–  Press → button until all faults still stored have been displayed and the display shows:
–  Press keys 0 and 5 for function “Erase fault memory” and confirm entry with Q key.
  
Rapid data transfer                 HELP
Select function XX
Indicated on display:
–  If the fault memory will not erase there is a fault still in the system and this must be rectified.
–  Press → button.
  
Rapid data transfer                   ->
Fault memory is cleared!
Indicated on display:
–  Press keys 0 and 6 for function “End data transfer” and confirm entry with Q key.
–  Carry out a further road test. Then read fault memory again. There should be no more faults displayed.
  
Rapid data transfer                 HELP
Select function XX

Final control diagnosis > < Fault code 16485 … 65535