Caution Release of the side mounted repeater turn signals is only possible in one direction. When removing, great care has to be applied with the side repeaters in situ as there is no way of determining the side of the fixed anchor point -1- and the side of the spring clip -2-. When using force to remove the light on the spring clip side there is a great danger that the turn signal or the vehicle paintwork surface will be damaged. |
|
–
| Switch off ignition and all electrical consumers and remove ignition key. |
–
| Carefully push turn signal to side -arrow- and lever it out of body (if necessary, mask paintwork with adhesive tape beforehand). |
–
| Pull rubber holder with push-fit bulb off lamp housing. |
–
| Pull push-fit bulb (12 V / 5 W) out of holder (do not turn). |
–
| Attach rubber holder with push-fit bulb to lamp housing. |
–
| Insert turn signal into body. |
–
| After completing installation, check function of turn signal. |
|
|
|