| –
| Open rear lid and support it. |
| –
| Position a small screwdriver beneath spring clip -2-. |
| –
| Raise spring clip -2- until it can be moved over ball socket in direction of -arrow-. |
| –
| Pull gas struts -1- from ball-head pins -3- and -4-. |
| After removing gas strut -1-, slide spring clip -2- back immediately. |
WARNING | Proceed with care if gas strut is reused. Spring clip must not be levered completely out of ball socket, as it will otherwise be damaged. Gas strut will spring out of mounting, causing damage or injury to operator. |
|
| –
| Specified torque for ball-head pins -3- and -4-: 22 Nm. |
|
|
|
