Note | t
| Vehicle must be standing on the ground to perform the basic adjustment of the rear lid. |
| t
| The rear lid lock is bolted directly to the rear lid. It does not have elongated holes, so it cannot be adjusted. |
| t
| Adjusting buffers cannot be used to adjust rear lid as they are in some other vehicles. They have the function of stabilising and damping the rear lid. |
| In conclusion, the rear lid adjustment is described in several steps. |
| Use the setting gauge -3371- → Rep. Gr.00 to check or adjust the gap dimensions. |
| –
| Adjust rear lid on rear lid hinges by loosening bolts -3- → Chapter. |
| –
| Adjust rear lid on rear lid hinges by loosening hexagon nut -3- → Chapter. |
Note | The lid is adjusted correctly if the gaps/shut lines are even all around, the lid is not too deep or too high and all contours align when the lid closed. |
|
|
|
