Golf Mk5
| Installing |
Note| t | Installation is only described for the left side. The procedure for the right side is similar. |
| t | Remove protective backing immediately before installation. Working temperature approx. 21 °C |
| t | Curing period after side member extensions are attached is about 4 hours at a room temperature of about 21 °C. |
| t | Adhesive remover -D 002000 10- and cleaning solution -D 009 401 04- must be used exclusively. |
| t | Bonding surfaces must be free of dust and grease. |
| t | The side member extensions must be bonded in place immediately after being cleaned. |
| l | Retaining strip is installed → Chapter. |
| – | Immediately before bonding side member extension, clean bonding surfaces thoroughly with adhesive remover -D 002000 10- and cleaning solution -D 009 401 04-. |
| – | Position side member extension -1- from above -arrows- evenly into retaining strip -3- and press side member extension into retaining strip until the two parts engage. |
| – | Now pull protective films -2- on side member extension -1- off upwards and backwards. |
| – | Only now remove film -4- and press side member extension -1- on forcefully in bonding area. |
| – | Tighten bolts -5-, beginning with front bolt on wing. |
