Golf Mk5
| Installing |
| – | Remove existing adhesive residues with adhesive remains remover -VAS 6349-. |
| – | Immediately before bonding the door outer seal, clean bonding surface thoroughly with adhesive remover D 002 000 10. |
| l | Surfaces to be bonded must be free of dust and grease and there should be no adhesive residue. |
| – | Align door outer seal with aperture -arrow b- towards door lock securing bolt. |
| – | Door outer seal vulcanised point -arrow c- should then be in middle of side member. |
| – | Pull protective backing off in stages and start fitting seal in upper radius -arrow a- of door. Do not pull outer door seal to avoid stretching seal. |
| – | Press complete adhesive area of seal -3- on door -1- all around using roller -3356-. |
| – | The seal is pushed aside -arrow a- when doing this so that the roller -3356- runs directly over the contact surface of the seal. |
| The roller can only apply the necessary force -arrow B- to the adhesive surface -2- when procedure described above is followed correctly. |
| – | If the seal is too long: cut seal to required length and press butt joints on well. |
| – | If the seal -3- comes loose in small areas again, press seal on well again using roller -3356-. |
Note| The door must not be closed for a period of 2 hours to ensure the door outer seal does not move or loosen again. |
