Changing motor - preselection switch recognition: |
Note t
| To interrupt the authorization signal and therefore to activate the switch recognition, the requirements described below must be fulfilled. |
t
| If this is not the case, it can lead to, that the drive does not correctly recognise the preselection switch and does not run to the selected positions. This can be seen if the sunroof stops approx. 10 cm before the fully closed position when the switch is in the closed position. |
WARNING Remove or install drive for tilting/sliding sunroof glass panel only when sunroof is closed (0 position ). |
The requirements for removing and installing drive are: Engine not running and ignition off, key not in ignition and door open. |
|
–
| Switch off engine and ignition, withdraw key and open door. |
l
| This condition must remain until drive has been installed. |
|
|
|