| Safety precautions for when working on seat occupied recognition |
| t
| Basic settings of seat occupied recognition control unit -J706- must be performed after each repair to front passenger seat in which the seat and/or the backrest was „detached“. Perform basic settings using a vehicle diagnosis tester in „Guided fault finding“ mode. |
| t
| The mat of the seat recognition sensor must not be kinked. |
| t
| A leaky mat must be renewed (repair kit). |
| t
| The pressure hose of the mat must not be kinked. |
| t
| The components of the seat recognition (repair kit) must not fall on hard surfaces. |
| t
| The components of the seat recognition must not come into contact with grease. |
| t
| There is always a danger that the components of the seat recognition may be damaged by pointed/sharp objects when working on the seat. This danger must be prevented. |
| t
| The mat, the fleece and all other covers must fitted without folds/creases. |
| t
| Ensure when installing that the seat padding and cover are correctly installed. |
| t
| Renew all padding clips and clip connections on cover, ensure they are positioned correctly on the seat. |
| t
| The basic setting of the system is only possible between temperatures 0 ° Celsius and + 40 ° Celsius. |
| t
| Ensure that no object is on the seat before and/or during the basic settings. |
| t
| The use of additional items on the seat, such as cushions or similar, impairs the functioning of the seat occupied recognition system and can therefore prevent the airbag system from functioning correctly. |
| t
| In area of seat occupied recognition sensor there should be no clips. This also applies in event of modifications to seat wiring harness. |
|
|
|
