volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing temperature flap control motorV68

Golf Mk5

Removing
Removing
–  Remove left footwell vent → Chapter.
–  Remove footwell trim on driver side → General body repairs, interior; Rep. gr.68.
   
–  Remove data bus diagnostic interface -J533- → Vehicle electrics; Rep. gr.97.
–  Remove bolts -3- (9 ± 1.3 Nm).
  Note
t  Do not remove bolts -1-.
t  Do not remove bracket -2-.
  N87-10206
–  Press bracket -1- in direction of brake pedal -arrow- and secure it there with a cable tie.
  N87-10392
–  Mark connector -C- to servomotor (risk of interchanging with other connectors of same design).
–  Disconnect connector -C- on temperature flap control motor -V68-.
–  Remove cover -A-.
–  Remove securing bolts -D- (1.4 Nm) and remove temperature flap control motor -V68--B-.
–  Release control motor lever -E- from connecting rod -F-.
  A87-0711

Installing > < Removing and installing temperature flap control motorV68