Golf Mk5
| Assembly overview - reverse shaft |
Note| After dismantling, always renew needle bearing in clutch housing and reverse shaft support. |
| 1 - | Clutch housing |
| 2 - | Needle bearing |
| q | Pulling out → Fig. |
| q | Pressing in → Fig. |
| 3 - | Reverse gear wheel |
| 4 - | Retaining ring |
| q | Always renew after removing. |
| 5 - | Synchromeshed gear for reverse gear |
| q | Remove retaining ring before renewing. |
| q | Shoulder faces reverse gear wheel |
| 6 - | Reverse shaft |
| q | Removing and installing → Chapter |
| 7 - | Needle bearing |
| q | Pressing out → Fig. |
| q | Pressing in → Fig. |
| 8 - | Reverse shaft support |
| q | Removing and installing → Chapter |
