volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing slave cylinder

Golf Mk5

Removing
Removing
–  First check whether a coded radio is fitted. If so, obtain anti-theft code.
–  With ignition switched off, disconnect battery earth strap → Electrical system; Rep. gr.27.
–  Remove complete air filter housing if it is over slave cylinder → Rep. gr.23 or → Rep. gr.24.
–  Remove securing clip -arrow 1- for gear selector cable from gearbox selector lever -A-.
   
–  Pull gear selector cable off pin.
Metal relay lever
–  Remove securing clip -arrow 2- for gate selector cable from relay lever -B-.
–  Pull gate selector cable from pin.
–  Pull securing clip -arrow 3- off relay lever -B- and remove relay lever.
Plastic relay lever
–  Remove relay lever together with cable end-piece → Chapter.
Continuation for all
–  Remove gearbox selector lever -A- by removing nut -arrow 4-.
  N34-1820
–  Remove cable support bracket from gearbox -arrows-.
–  Then raise and secure gear selector cable and gate selector cable.
–  Place a lint-free cloth under slave cylinder.
  N34-1821
–  Pull clip -A- for line between master and slave cylinders out of slave cylinder to stop.
–  Pull line between master and slave cylinders out of support -C-.
–  Pull line between master and slave cylinders -B- out of slave cylinder and seal opening.
–  Unbolt slave cylinder -arrows- and remove.
  Note
Do not depress clutch pedal.
  A30-0062

Installing > < Removing and installing slave cylinder