volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pump > < Removing

Golf Mk5

Installing
Installing
   
–  Renew O-rings -C- of gearbox oil cooler -B-
–  Set gearbox oil cooler -B- in place. When doing this, note O-rings -C-.
–  Screw in new bolts -A- and tighten to 20 Nm + 90° (1/4 turn).
  A37-0669
–  Attach coolant hoses to gearbox oil cooler and remove hose clamps to 25 mm -3094-.
  N34-10215
–  Insert new filter with shoulder downwards and tighten cover to 20 Nm.
–  Install battery carrier and battery → Electrical system; Rep. gr.27.
–  Check coolant level and top up with coolant as needed → Rep. gr.19.
–  Following repairs, fill with oil without renewing filter → Chapter.
  Caution
Do not start engine while checking coolant level, because no dual clutch gearbox oil is filled yet.
  N30-10082

Removing and installing oil pump > < Removing