Golf Mk5
| Overview of selector mechanism up to 02.2009 |
| 1 - | Selector cover with knob |
| q | Cover unclipped for emergency release → Chapter |
| q | Before removing knob, pull button out past its pressure point and secure with cable tie or wire |
| q | Do not press button in, or knob must be dismantled and prepared for installation → Chapter |
| 2 - | Selector lever and selector mechanism |
| q | With selector lever lock solenoid -N110- |
| q | Emergency release → Chapter |
| q | Brief instructions for removing and installing: |
| – | Remove centre console |
| – | Remove Bowden cable from gearbox → Chapter. |
| – | If necessary, disconnect or remove parts of → exhaust system; Rep. gr.26. |
| – | Remove heat shield beneath vehicle. |
| – | Adjust selector lever cable after installing → Chapter. |
| 3 - | Bolt with spring |
| q | 3 Nm |
| 4 - | Pin |
| q | Removing → Chapter |
| q | Do not grease |
| 5 - | Securing clip |
| q | Always renew after removing |
| 6 - | Nut |
| q | 9 Nm |
| q | Qty. 4 |
| 7 - | Selector housing |
| q | With seal |
| 8 - | Selector lever cable |
| q | Do not grease |
| q | Removing and installing → Chapter |
| q | Checking → Chapter |
| q | Adjusting → Chapter |
| 9 - | Securing clip |
| q | Always renew after removing |
| 10 - | Securing clip |
| q | Always renew after removing |
| 11 - | Hexagon nut with washer |
| q | 8 Nm |
| q | Qty. 4 |
