During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.
t
Place a lint-free cloth under the master cylinder.
–
Clamp off supply hose to master cylinder using hose clamp -3094-.
–
If necessary, loosen spring-type clip -3- with assembly tool -VAS 5024- and pull supply hose off master cylinder.
–
In addition, for disconnecting, you can close it with the sealing tool -T10249/1- (⇒ illustration above).
–
Release securing clip -2- using screwdriver or a pointed object and pull line -1- off master cylinder.
–
Unclip clutch position sender -G476- from master cylinder -arrow- and remove with electrical connector attached -4-.
Note
When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills.