volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing clutch position senderG476

Golf Mk5

Removing
Removing
LHD
–  First check whether a coded radio is fitted. If so, obtain anti-theft code.
–  With ignition switched off, disconnect battery earth strap → Electrical system; Rep. gr.27.
–  Remove air filter with engine cover if it is located close to the battery → Rep. gr.24.
–  Remove battery and battery tray → Electrical system; Rep. gr.27.
Right-hand drive
An insulation mat is installed in conjunction with some engines. Appearance may be different from that illustrated.
   
–  If fitted, remove the insulation mat from the hose/pipe line -arrows-.
  N34-11205
In some vehicles, clutch position sender -G476- is located behind a line for air conditioning system -arrow-.
Continuation for all
  N30-10221
If a pipe/hose line or plastic line -1- with a round component is installed directly beneath the master cylinder, the pipe/hose line or plastic line must be removed.
  Note
During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.
  N30-10122
–  Clamp off supply hose to master cylinder with hose clamps up to 25 mm -3094-.
  A30-0127
–  Release securing clip -2- with a screwdriver or a pointed object and pull out of master cylinder to stop.
–  Remove pipe/hose line -1- from master cylinder and seal it.
–  Unclip clutch position sender -G476- from master cylinder -arrow- and remove.
–  Disconnect electrical connector -4-.
  N30-10122

Installing > < Removing and installing clutch position senderG476