Golf Mk5
Repairing gear lever and selector housing (from 11.06) |
Note
t | Lubricate bearing positions and sliding surfaces. |
t | Allocate grease using → Electronic parts catalogue (ETKA). |
t | Dismantling and assembling selector mechanism → Chapter. |
1 - | Base plate |
q | Bend open tabs to remove |
q | Always renew |
2 - | Seal |
q | Always renew |
3 - | Gear lever |
q | Can be removed and installed with gear lever guide → Item installed |
4 - | Damping washer |
q | Push onto gear lever up to stop -arrow- |
5 - | Securing clip |
q | Do not damage cables when removing |
q | Always renew |
6 - | Gate selector cable |
q | Lever off gate selector lever |
q | Press onto gate selector lever inside selector mechanism |
q | Installation position → Chapter |
7 - | Bush |
8 - | Gear selector cable |
q | Lever off gear lever guide |
q | Press onto gear lever guide inside selector mechanism |
q | Installation position → Chapter |
9 - | Damping |
10 - | Ball socket |
q | Will be damaged when removed. |
q | Always renew |
11 - | Bush |
12 - | Securing clip |
q | Removing and installing → Fig. |
13 - | Compression spring |
q | Removing and installing → Fig. |
14 - | Bush |
15 - | Gear lever guide |
16 - | Hexagon nut M8, 25 Nm, hexagon nut M 6, 8 Nm |
q | Qty. 4 |
17 - | Seal |
q | Between selector housing and underbody |
q | Self-adhesive |
q | Bond to selector housing |
18 - | Selector housing |
q | With compression spring and gate selector lever |
q | Compression spring and gate selector lever cannot be removed |