volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Renewing valve stem seals

Golf Mk5

Removing
Removing
(With cylinder head installed)
–  Remove camshaft. → Chapter
–  Remove bucket tappets and place them with the contact surface downwards. When doing this, ensure that the tappets are not interchanged.
–  Set piston of respective cylinder to top dead centre (TDC).
   
–  Insert valve assembly device -2036- and adjust mounting to height of studs.
–  Remove valve springs using valve lever -VW 541/1A- and press tool -VW 541/5-.
  Note
The valves are supported by the piston crown.
  N15-0259
–  Pull off valve stem seals using puller -3047 A-.
  N15-0260

Installing > < Renewing valve stem seals