Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder diesel engine (2.0 l engine, 2-valve, SDI) | Engine cylinder head, valve gear | Cylinder head

Removing and installing cylinder head

Special tools and workshop equipment required

t	Drip tray -V.A.G 1306-

t	Torque wrench (5...50 Nm) -V.A.G 1331-

t	Torque wrench (40...200 Nm) -V.A.G 1332-

t	Hand vacuum pump with accessories -V.A.G 1390-

t	Water drainage container -V.A.G 1390/1-

t	Retainer -T10014- (only vehicles ► 05.05)

Special tools and workshop equipment required

t	Support bracket -10-222A- with adapters -10-222A/13- (only vehicles ► 05.05)

Note

All cable ties which are opened or cut through when cylinder head is removed must be replaced in the same position when cylinder head is installed.

WARNING

When doing any repair work, especially in the engine compartment, pay attention to the following due to the cramped conditions:

t	Route all the various lines (e.g. for fuel, hydraulics, activated charcoal filter system, coolant, refrigerant, brake fluid and vacuum) and electrical wiring in their original positions.

t	Ensure that there is sufficient clearance to all moving or hot components.

Volkswagen Workshop Service and Repair Manuals