volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing camshaft

Golf Mk5

Removing
Removing
–  Remove toothed belt → Chapter.
   
–  Remove securing bolts for camshaft toothed belt pulley -1-.
–  Pull camshaft toothed belt pulley off hub.
  N15-0232
–  Loosen hub securing bolt -1-.
–  To do this, use counter-hold tool -T10051-.
–  Loosen hub securing bolt about 2 turns.
  N15-0271
–  Apply puller -T10052- and screw securing bolts -1- into hub.
–  Apply tension to hub by evenly tightening puller until hub separates from taper of camshaft.
  Note
When doing this, hold puller with 30 mm spanner.
–  Remove hub from taper of camshaft.
–  Remove cylinder head cover.
  N15-0280
–  Mark rocker arm shafts using a permanent felt tip marker to prevent interchanging. This will prevent having to perform basic settings of unit injectors -arrows-.
–  Remove rocker arm shafts.
  Note
First loosen both outer and then inner securing bolts respectively.
–  Remove tandem pump → Chapter.
  A15-0531
–  First remove bearing caps 5, 1 and 3. Then loosen bearing caps 2 and 4 alternately and diagonally.
–  Remove camshaft.
  A15-0532

Installing > < Removing and installing camshaft