Pressing in sealing flange with sender wheel |
Note t
| The sealing flange with a PTFE seal is equipped with a sealing lip support ring. This support ring serves as a fitting sleeve and must not be removed prior to installation. |
t
| Sealing flange and sender wheel must not be separated or turned after removal from packaging. |
t
| The sender wheel is held in its installation position on the assembly device -T10134- by a locating pin. |
t
| Sealing flange and seal are one unit and must be replaced together with the sender wheel only. |
t
| The assembly device -T10134- is held in its position relative to the crankshaft by a guide pin inserted into a hole in the crankshaft. |
|
|
|